Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!

model scale railroad houses to construct ho scale n scale oo gauge

Fixing an Electrical Problem in a Locomotive

Craig sent in this question for readers:

“My LGB 251902-3 (2051S Cat#) will not pick up electricity from the rail.  My smaller Furka Oberalp works just fine on the track.  I have found that when I test the pick up plates, there is no circuit between the plates, meaning there is no voltage to the motors. It was working fine until just recently, but has been sitting on a shelf in my workshop for about 3 weeks.Any suggestions?”

3 Responses to Fixing an Electrical Problem in a Locomotive

  • Randall Styx says:

    You’ve started on the right “track”: you’ve tested the track with another loco. You’ve also tested the pads. So, you know the problem is somewhere on or in the loco. Somewhere there’s a break in the circuit. That break could be anywhere, from the pads to the wires to the connectors to the motor(s) to the windings inside the motor.

    Are the pads oxidized, dirty, or corroded? If they’re clean metal, you have to go deeper. Take the shell off and apply either operating or test current directly to the contacts on the motor. If the motor runs or you get a current, the problem is between the pads and the motor. If not, the problem is inside the motor.

    Examine the solder joints. Are they metallic and shiny or dull and chalky. Poor solder joints (dull and chalky) can break down, especially with movement. Revitalize any poor solder joints. (Just because it may have been soldered in the factory does not guarantee good solder joints.)

    Check the wires for kinks or places where they might appear thinner. (The thin section could be from insulation that has collapsed over an empty space created when a broken wire pulled apart inside.) Move them around a bit and retest, or move them while you’re testing.

    Closely examine places where wires are attached to moving parts (like the pads). While wires can bend, every time they bend they become slightly more brittle. Eventually, they will break. Yes, even copper will do this. The most likely spots are where the wire is attached to something that does not move or to where the wire is held fast by solder.

  • Anthony Germagliotti says:

    It sounds like you are on the right track by checking the pickups , but it could be the motor is stuck
    I would turn the motor by hand and put an ohm meter across the brushes, when the brushes hit
    both sides of the com you will see a reading saying that the motor is okay

Leave a Reply

Your email address will not be published. Required fields are marked *

Add a photo or image related to your comment (JPEG only)

Reader Poll

Which scale of model trains do you operate or prefer?

View Results

Loading ... Loading ...

SUBMIT YOUR QUESTION

Download Your Free Catalog

Use Tiny Railroad Micro Controllers

N Scale Track Plans

Watch Video

Model Train DCC HELP

Model Train Help Ebook

NEW TO MODEL TRAINS?

FREE Tour Inside Club

Take a FREE tour inside the club.

Scenery Techniques Explained

Scenery & Layout Ideas

Model Railroading Blog Archive