Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!
Wiring 101
Steve sent in this question:
“Hello, I just purchased an atlas HO layout: senior twice around HO 5″. Is there a step by step diagram on how to wire this set up my grandson and I are getting frustrated?”
Maybe Steve could add some more detail to help readers who want to provide a quality answer.
6 Responses to Wiring 101
Leave a Reply
Reader Poll
Loading ...SUBMIT YOUR QUESTION
Download Your Free Catalog
Use Tiny Railroad Micro Controllers
N Scale Track Plans
Watch Video
Model Train DCC HELP
Model Train Help Ebook
NEW TO MODEL TRAINS?
FREE Tour Inside Club
Take a FREE tour inside the club.Scenery Techniques Explained
Scenery & Layout Ideas
Steve,
There are several good wiring books out there. Without knowing your exact problem it is very hard to give you any advice.
Wiring needs are quite different for the simpler DC compared to DCC. Which of these are you trying to set up and what exactly is the problem?
Robert
When I wired my layout I drew a sketch of my railroad tracks and divided it into about 5 different blocks using insulated rail joiners to separate the different blocks. If I can remember (back in the mid 1980´s) I only used the insulated rail joiners on one side of the track (the positive side) and kept the other side as one continuous rail. Even reversed, they were still divided into blocks as the positive side became the negative side. I have a DC only railroad so this worked out well for me. I do not know about DCC.
It should be fairly straight forward. There are no reversing loops and you don’t mention you are using DCC, so I suspect your issue is that trains are loosing speed as they go around the layout. If that is your issue then you need more feeds to the track. I would run a large (14 or 16 gauge) wire under the layout that is connected to your power supply. You would run feeder wires off of this to supply power to your track. Start with two sets of feeds. One wherever you want and the second set halfway around the track from where the first ones were installed. Attaching the feeder wires to the track can be a problem. If you don’t want to solder them then Atlas sells rail joiners with wire soldered to them. Replace the existing joiners with these where needed and connect the joiner wires to the larger wire running under your layout. Here you can solder or use suitcase connectors if you are careful to have wire gauge that the connectors can work with.
Can you post a diagram of the layout and describe exactly what your problem is ?
A model shop would be able to supply a book teaching the basics of model layout wiring.
Please, can someone help me out on how to wire-up-and solder, Peco coloured wires on my double/single slip crossings,
Sending you the pictures of the double/single crossing, Does someone have pictures of the actual crossing code 100, showing where to connect/solder the Pecos black and red wires too, I watch; youtubes!. they show the underneath silver wire sticking out the side of both the rails! do not show how they do this; My double/single slip crossings do not show this
Had already soldered a red and black wire, to the points; As shown in the pictures with the frog silver wire bedded into the sleepers! I had both silver and blue wire twisted together and shrink tube applied using a soldering iron, The other turnouts I do have don’t show the loose silver wire…Please can you send any pictures of the actual rails you have – instructions I am not sure of!
Nigel