Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!

model scale railroad houses to construct ho scale n scale oo gauge

Switch Wiring Question

Ren T models in N scale and asks:

“Can I wire a red & green LED signal status light to DC Bachmann turnout control switch? I want a green light for mainline direction and and a red light when the switch is not in position to direct trains off the mainline?”

Send in your question for publication. There is a link below.

View the comments, or add a comment to Ren’switch wiring question. There is a link for that below too.

6 Responses to Switch Wiring Question

  • phil johnson says:

    some switch machines have extra contacts for signals and to polarize the frog. If your Bachmann has these you are in luck. Although I can’t recall ever seeing them. You might consider dropping Bachmann a email.

  • Jeff Cohen says:

    If you want to go old school, check out the Atlas Snap Relay. The Bachmann switch controller is momentary so as not to burn out the coils in the turnout. If you connect the three wires from the control to the Snap Relay as well as the turnout, the switch control will actuate both at the same time. The Snap relay has additional screw terminals that you can connect to your status light as long as you make sure there’s a resistor in the connection so you don’t burn out the LEDs. Note, Bachmann uses proprietary cable connectors, so you’ll need to be doing some cutting and soldering (or using terminal blocks with a screwdriver).

  • Gio says:

    The relay coil uses 12V to activate, but when the momentary voltage cuts out, the reverse voltage spike could be in the thousands. So be very careful if there is no reverse voltage protection diode installed.

  • Adam Young says:

    I used LED lights with a latching relay to make one that works off the momentary switch.

  • Wally says:

    Use a ‘ Snap Relay” in parallel with the switch relay. I use this these snap relays in my layout.

  • W Rusty Lane says:

    I also use Atlas snap relays but I don’t use them with lights or LED’s. I guess I could use lights or LED’s but I use the snap relays to change the voltage on the frogs on the diversionary route. I have these wired to two sets of switches or turnouts. Works well after you figure out how to wire them.

Leave a Reply

Your email address will not be published. Required fields are marked *

Add a photo or image related to your comment (JPEG only)

Reader Poll

Which scale of model trains do you operate or prefer?

View Results

Loading ... Loading ...

SUBMIT YOUR QUESTION

Download Your Free Catalog

Use Tiny Railroad Micro Controllers

N Scale Track Plans

Watch Video

Model Train DCC HELP

Model Train Help Ebook

NEW TO MODEL TRAINS?

FREE Tour Inside Club

Take a FREE tour inside the club.

Scenery Techniques Explained

Scenery & Layout Ideas

Model Railroading Blog Archive