Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!

model scale railroad houses to construct ho scale n scale oo gauge

Electrical Switch Relay For LED

Peter M asks readers:

I would like to run LED street lights off of my garden railway track. As LED’s only work in one direction can any one tell me what I need in the way of an electrical switch (relay) to enable the lights to work when I change direction?

Post your answer below.

5 Responses to Electrical Switch Relay For LED

  • Geoff says:

    Do you have just the one connection from the track to the street lights? You could wire a DPDT switch such that when you change direction you can throw the switch to keep the lights lit up. I am not sure about wiring the lights to the track though. It seems to me that your lights would be constantly dimming and brightening, and whenever you stopped to change direction they would go out. It will be more effort, but you might be better off in the long run to have a separate power supply for the lights.

  • Edwin Barlow says:

    You don’t say in your question whether you are running analogue DC or DCC. I have found that led’s will illuminate on ac but for only half the time, flicker is quite realistic, but you do need a suitable resistor in circuit to protect against surges. If running in DC a simple bridge rectifier across the supply with the output to the lighting should be adequate. Don’t forget the current limiting resistor as before

  • As commented above, connect the tracks to the AC input of the bridge rectifier. and the plus and minus output to the LED via a current limiting resistor. You can also add a SPST switch in the plus line to switch the LED’s on and Off. If the LED’s flicker a electrolytic capacitor can be added over the + / – wires to smooth the voltage.This way the polarity of the tracks do not matter as the diode bridge will sort it out.

  • Kevin Ching says:

    If you use a bridge rectifier you can wire the LEDs to the + and – connection and wire the ~ to the track that way it it will always be in the right configuration for the LEDs just make sure the bridge rectifier has sufficient amperage for your layout.

  • Jay Ross says:

    As the comments above stated, you need to use a bridge rectifier between the track voltage and the LED’s. However, LED’s need to have the current regulated to around .015 amps, anything higher will damage them. You can find them at Newark Elctronics, here is the info: Invoice:
    Line No: 1 Stock No:
    Manufacturer Part No:
    UOM:
    Quantity: Price:
    Extended Price:

    60R6439
    NSI50010YT1G
    Tape and Reel Cut 1
    120

    $0.186
    $22.32

Leave a Reply

Your email address will not be published. Required fields are marked *

Add a photo or image related to your comment (JPEG only)

Reader Poll

Which scale of model trains do you operate or prefer?

View Results

Loading ... Loading ...

SUBMIT YOUR QUESTION

Download Your Free Catalog

Use Tiny Railroad Micro Controllers

N Scale Track Plans

Watch Video

Model Train DCC HELP

Model Train Help Ebook

NEW TO MODEL TRAINS?

FREE Tour Inside Club

Take a FREE tour inside the club.

Scenery Techniques Explained

Scenery & Layout Ideas

Model Railroading Blog Archive