Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!

model scale railroad houses to construct ho scale n scale oo gauge

Magnet Wire or Stranded Wire For Rewiring Locomotives?

Bradon asks:

“I was going to use an old roll of magnet wire to rewire locomotives, but a friend said I should use stranded teflon coated wire instead. Thoughts?”

Post your comment (and view comments) below.

4 Responses to Magnet Wire or Stranded Wire For Rewiring Locomotives?

  • Don Peterson says:

    Definitely use stranded for most flexibility and stranded has better current carrying capacity than solid (magnet) wire. Also the colors will keep wiring easier to identify.

  • Steve B says:

    Magnet wire is regular wire that has been coated with an “enamel paint” The coating is very tough, but it can be scratched off. If touching almost any hard surface and loose enough to vibrate, it will chip off presenting a bare wire that could short out. Teflon coated, stranded wire is very flexible and can be easily routed and is not easy to rub through.

  • Bernard says:

    It depends on what you are re-wiring. If there is relative movement between the parts being connected (such as bogie pick-ups to frame or motor), then it would be advisable to use stranded wire. For smaller locos, 00 or HO or N the wire used for decoder wiring (teflon-coated stranded) should be enough. Allow a loop or two to allow flexibility.
    If the wiring is from fixed contacts to the motor, (typically a fixed insulated “pad” which carries the wheel pickups on a steam loco) then stranded wire is not necessary, just wire sufficient to the current demands of the motor of the locomotive.
    On bigger, heavier, older locos ensure the wire is sufficient for current required, you do not need to put resistance between the current supply and the motor.

  • David Stokes says:

    If by “rewiring locos” you mean replacing the wire windings in the loco motors then “magnet wire” is the only way to go, but very, very fine gauge. If you mean for running from the motor to the pickups or lights then this is a recipe for disaster – the clear varnish or Teflon coating will rub off in time creating short circuits and dead locos.

Leave a Reply

Your email address will not be published. Required fields are marked *

Add a photo or image related to your comment (JPEG only)

Reader Poll

Which scale of model trains do you operate or prefer?

View Results

Loading ... Loading ...

SUBMIT YOUR QUESTION

Download Your Free Catalog

Use Tiny Railroad Micro Controllers

N Scale Track Plans

Watch Video

Model Train DCC HELP

Model Train Help Ebook

NEW TO MODEL TRAINS?

FREE Tour Inside Club

Take a FREE tour inside the club.

Scenery Techniques Explained

Scenery & Layout Ideas

Model Railroading Blog Archive