Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!

model scale railroad houses to construct ho scale n scale oo gauge

Wiring Turnouts and Control Panel

Ray asks:

I want to switch my HO scale turnouts  with a single switch to also supply power the track and illuminate an LED on the control panel. I am using PECO motors on PECO track. I think that a continuous supply to PECO motors causes them to burn out.  I have a number of double pole double throw switches but I am unsure how to wire it to prevent motor burnout. Any thoughts would be appreciated.”

10 Responses to Wiring Turnouts and Control Panel

  • Geoff says:

    Well, the short answer is that you can’t, since Peco motors want a “passing contact” switch, or a probe, to momentarily supply power to the motor to cause it to change. And you can’t do that with a DPDT switch. You can get accessory switches that are operated by the turnout (Peco ref PL-13) and you could probably use these to control the power to the track, and then use a “proper” turnout motor switch to operate the turnout.

  • Edwin says:

    I would suggest you use a capacitor discharge unit together with a probe or spdt non latching toggle switch. This overcomes continuous current draw, the cdu recharges quickly. There wiring diagrams freely available on the net. If you can’t find one I can supply the diagram and components list.

  • Bernard says:

    I think there are latching relays which will switch contacts with a pulse, just like the Peco point motor. You could drive such a relay in parallel with your point motor, and use its contacts to supply power to the LED indicators. One pulse will change the relay state from A to B and it will stay there. The next pulse will change the state back from B to A, and it will stay in that state until the next pulse changes it again. See the websites below for an explanation of a latching relay.
    https://uk.rs-online.com/web/generalDisplay.html?id=ideas-and-advice/latching-relays-guide and
    http://www.omron-ap.com/service_support/FAQ/FAQ02822/index.asp

  • Joe Graffi says:

    That is why I use tortoise switch motors. They are made to not burnout (but I use momentary switches anyway) AND they have 2 S.P.D.T. switches built in.

  • Ray Glew says:

    Thank you to all for the response. Much appreciated.

  • Stewart says:

    I’ve used servo motors with twin micro switches mounted under the board and steel rod size of a paper clip works the point, They run on 5 volts, one micro switch controls positive or negative to the electro frog, the other switch controls the leds that give direction simple to wire and give a nice point operation. It’s an alternative option.

  • David Krause says:

    A momentary SPDT switch should work well with a PECO turnout. PECO turnouts have a kind of “detent” that holds the points against the rail when there is no power applied to the switch motor. Using a momentary switch allows the motor to be energized only when pressure is applied to a toggle handle. When the toggle handle is released, the switch returns to a neutral position and power is not applied continuously.

  • Ray Glew says:

    Thank you for the replies

Leave a Reply

Your email address will not be published. Required fields are marked *

Add a photo or image related to your comment (JPEG only)

Reader Poll

Which scale of model trains do you operate or prefer?

View Results

Loading ... Loading ...

SUBMIT YOUR QUESTION

Download Your Free Catalog

Use Tiny Railroad Micro Controllers

N Scale Track Plans

Watch Video

Model Train DCC HELP

Model Train Help Ebook

NEW TO MODEL TRAINS?

FREE Tour Inside Club

Take a FREE tour inside the club.

Scenery Techniques Explained

Scenery & Layout Ideas

Model Railroading Blog Archive