Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!

model scale railroad houses to construct ho scale n scale oo gauge

Solving Point Problem When Running Switcher Locos

Hugh asks readers:

“I have a Peco electrofrog point and run my 3 large locos ok. The problem is when I run my 2 small switcher engines that pass over the point (frog end) they briefly stall before moving on. It only happens in one direction so I’m a bit baffled. Help please.”

Use the COMMENTS link under this post to add your suggestion(s) and view the answers. Use the ASK A QUESTION link to submit your own question for publication.

6 Responses to Solving Point Problem When Running Switcher Locos

  • geoff says:

    How is the frog powered? Are you relying on the physical contact between the blade and the stock rail? Try applying pressure to the point blade when the train goes over it and see if the stall goes away. (A large locomotive could be long enough to be picking up power from the rails at either end of the points, where a small one needs to pick up power from the blade.)

    If this is the problem, it might be caused by a piece of grit or other dirt preventing a proper contact between the blade and the rail, or the spring is getting weak. And the solution is to power the frog directly with a polarity switch, either a mechanical one attached to the point mechanism or an electronic one.

  • Rudy says:

    Good question… I have the same problem with a small ” PIKO ” engine. My theory is that when the traction tire is opposite the frog, then, for the length of the frog, power is lost. Turn the engine around, then the traction tire passes over the frog, and the powered wheel, (wheels), maintain contact with the “live” rail. Just my theory…don’t know for sure…

  • Doc says:

    I have found that adding a power wire to the sections of track between the switch points and the frog solves the problem. Without them , the power to this section of track is totally dependent on a good connection where the switch points touch the outer rails.

  • David Stokes says:

    For guaranteed power right through the Electrofrog point, the frog must be powered. Get on to Youtube, Peco has a number of tutorials how to do this. Charlie Bishop also has a very good tutorial.

    Once you have wired the frog this issue will disappear

  • George says:

    Had the same problem, how I resolved it was to wire the frog to a two-way toggle with and toggle the Power to the direction of travel, namely left or right to the center pole or frog, that cured all my problems now every thing runs as it should, its a quick fix. Hope this helps.

  • Hugh says:

    thanks for input much appreciated

Leave a Reply

Your email address will not be published. Required fields are marked *

Add a photo or image related to your comment (JPEG only)

Reader Poll

Which scale of model trains do you operate or prefer?

View Results

Loading ... Loading ...

SUBMIT YOUR QUESTION

Download Your Free Catalog

Use Tiny Railroad Micro Controllers

N Scale Track Plans

Watch Video

Model Train DCC HELP

Model Train Help Ebook

NEW TO MODEL TRAINS?

FREE Tour Inside Club

Take a FREE tour inside the club.

Scenery Techniques Explained

Scenery & Layout Ideas

Model Railroading Blog Archive