Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!
Atlas #200 Snap Relay for LED Trackside Lamps
John (not the one in the earlier post) has sent in this HO question for readers to hopefully answer. You can comment below.
“I am trying to wire an Atlas #200 snap relay for trackside signal lamps using red and green LED lamps. I have followed the directions in the package but I am not sure were to install the resistors. Also the LED need to have a positive and negative feed. How to you know on the AC side of the power pack which is positive and negative?”
One Response to Atlas #200 Snap Relay for LED Trackside Lamps
Leave a Reply
Reader Poll
Loading ...SUBMIT YOUR QUESTION
Download Your Free Catalog
Use Tiny Railroad Micro Controllers
N Scale Track Plans
Watch Video
Model Train DCC HELP
Model Train Help Ebook
NEW TO MODEL TRAINS?
FREE Tour Inside Club
Take a FREE tour inside the club.Scenery Techniques Explained
Scenery & Layout Ideas
resistors one goes on one leg of each led.on power unit there should be to sets of out puts one for track (ac )one set for accessory it will be dc this is where you hook up led you may have notice one leg of led longer then other this is how you tell – from + as long as you have resistor on one leg of led even if you hook it up wrong it will not hurt it just well not come on if you have hooked them up WITH OUT resistor they are most likely burn out hope this helps