Comments on: Rivarossi Pullman Car Wheels and Axles https://blog.model-train-help.com/2013/11/rivarossi-pullman-car-whhels-and-axles.html?utm_source=rss&utm_medium=rss&utm_campaign=rivarossi-pullman-car-whhels-and-axles Model railroads and model trains Fri, 22 Nov 2013 01:54:59 +0000 hourly 1 https://wordpress.org/?v=6.9.4 By: Bill https://blog.model-train-help.com/2013/11/rivarossi-pullman-car-whhels-and-axles.html#comment-4739 Fri, 22 Nov 2013 01:54:59 +0000 http://blog.model-train-help.com/?p=2878#comment-4739 The use of a 2-56 screw is a good idea. You can add a shim of .010 plastic to fill in the hole if it is oversize, don’t glue the plastic the screw will hold it. I am converting all of my cars to use the screws to hold the trucks, this makes for a more stable car without the wobble from loose trucks. One other quick fix you can use is to use a pair of needle nose pliers to pinch the end of the pin to make it larger and press fit it into the hole. Good luck, Bill

]]> By: R. Olivarez https://blog.model-train-help.com/2013/11/rivarossi-pullman-car-whhels-and-axles.html#comment-4737 Wed, 20 Nov 2013 22:00:42 +0000 http://blog.model-train-help.com/?p=2878#comment-4737 Scott’s comments makes sense if the trucks themselves are the problem. Don’t try to glue or epoxy them. for it may secure the truck to the car body, not allowing it to flex or move freely when going into a turn.

If the axles are coming off while the trucks remain attached to the car, it sounds as if the dimples of the trucks no longer can hold the axles. Most trucks are made of plastic, you could take a hair dryer and heat the trucks up a bit and gently press the sides in a tad and hold them in place ’till the truck is cool, so that the dimples can hold the axles again without causing too much undue friction. If the trucks are made of thin sheet metal you could try and gently press the sides inward, but if they are made of pot metal then I suggest replacing the trucks in total.

]]> By: Scott https://blog.model-train-help.com/2013/11/rivarossi-pullman-car-whhels-and-axles.html#comment-4730 Mon, 18 Nov 2013 13:59:01 +0000 http://blog.model-train-help.com/?p=2878#comment-4730 Can you replace the pins with screws? Something like a 2-56 screw May have to enlarge the hole in the truck to accommodate the screw..

]]>