Comments on: Power Source for LED Lighting https://blog.model-train-help.com/2017/05/power-source-for-led-lighting.html?utm_source=rss&utm_medium=rss&utm_campaign=power-source-for-led-lighting Model railroads and model trains Fri, 16 Jun 2017 07:38:30 +0000 hourly 1 https://wordpress.org/?v=6.9.4 By: Trevor Davies https://blog.model-train-help.com/2017/05/power-source-for-led-lighting.html#comment-18699 Fri, 16 Jun 2017 07:38:30 +0000 http://blog.model-train-help.com/?p=4453#comment-18699 If you search Ebay for cheap Chinese variable voltage regulator “DC-DC Buck Converter Step Down Module LM2596 Power Supply Output 1.5V-35V” only a couple of £s or so. Set to 1.8 or whatever you need for the type of LED you are using. No resister needed and can cope with a large number of LEDs.

]]> By: Phil Malavolta https://blog.model-train-help.com/2017/05/power-source-for-led-lighting.html#comment-18696 Fri, 16 Jun 2017 04:11:03 +0000 http://blog.model-train-help.com/?p=4453#comment-18696 Depending on the way you wish to use them would help a lot. I they will be on all the time, either of the other 2 comments would be fine. If you want to turn them on and off at various times, or for other uses that will turn on and off or sequence. You might want to look at an Arduino and look at learning how to use one. Hope this will give you some great ideas.

]]> By: Chris Manvell https://blog.model-train-help.com/2017/05/power-source-for-led-lighting.html#comment-18608 Wed, 07 Jun 2017 18:30:02 +0000 http://blog.model-train-help.com/?p=4453#comment-18608 Rather than using a transformer and converting the output to DC, I use a cheap 9Vdc 2Amp powerpack (loads of them on eBay) with a 1k resistor in series with each LED. 2A is an overkill but I also have a lot of filament bulbs in groups of 3 in series. NB. The longer lead on the LED is the anode and must be connected to the +ve supply. The resistor can be on either side of the diode but best to be consistent.
Incidentally, if you are working in the steam era, use yellow LEDs. The ‘white/daylight ones look like arc lights. Fine tho’ for modern as the white ones mimic fluorescent lighting.

]]> By: Bill https://blog.model-train-help.com/2017/05/power-source-for-led-lighting.html#comment-18501 Fri, 26 May 2017 18:59:06 +0000 http://blog.model-train-help.com/?p=4453#comment-18501 Jose,
You don’t say what you are doing with these lights.Regardless of what you do with them led’s require a dc power source. They are very efficient and as such you don’t need much power. Generally the problem is too much power and this is compensated for by using a resistor before the led. Too much power and the led’s blow right away. The size of resistor is determined by the number of lights, there electrical characteristics (slightly different depending on colour) and the amount of power being supplied. A quick search on line will get you all the information you need to determine power supply requirements and resistor size.depending on what you are trying to do.

Bill

]]>