Comments on: Wiring Tiny LED Lights

By: Cecon

Cecon — Thu, 09 Sep 2021 07:49:09 +0000

By: Bob Rimm

Bob Rimm — Tue, 28 Jul 2020 15:52:11 +0000

The wire for LED’s varies depending on the light output and size, which determines the current that the LED will use. The 2 big issues with LED’s are making sure that you have the voltage polarity connections and correct voltage. Too high a voltage will usually give you a second of bright light before it burns out. If there is a resistor soldered to the Led, you should have documentation on what voltage is needed for it to work properly. You also need to know which lead gets the + and the – power connection. To learn about how to use LED’s, go on line and look up how to verify which LED leg is + and – along with what happens if you connect it backwards. (There is a good chance it will burn out the LED) Depending on the type of device, LED’s have several operating voltages and current requirments to operate! Go to http://www.DigiKey.com and look up Led’s to get an idea on how to properly use them.

By: Mel Sloan

Mel Sloan — Tue, 28 Jul 2020 12:39:41 +0000

I attached 30 ga, stranded wires about 8″ long to my street lamps so I could pass the wires through top of my layout.

By: Dale Arends

Dale Arends — Thu, 23 Jul 2020 16:24:01 +0000

Simply solder them to longer, lightweight wires. I would recommend using 18 gauge or thinner wire for the flexibility and because the lights really don’t draw much power. Be sure to protect the joints with heat-shrink tubing, or other means, which will also help reduce stress on the joint.