Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!

Brand New! Just Released! 15 Background City Buildings To Download and Build

Engine Stalls On Straights

Lester sent in this question:

“I bought a Bachmann engine that must be more than 30 years old and tried it out on my basic oval test track which has a straight piece on each side. It runs ok on the curves but is starts to stall on the straights. My voltmeter showed no power loss. I then cleaned the track, but it still runs ok on the curves and slows a stall on the straights. It baffles me. Any thoughts?”

To add a suggestion or comments to assist Lester, please use the COMMENTS link under this post. No login required.

9 Responses to Engine Stalls On Straights

  • John Howiesays:

    Have you checked the track guage on the straight bits?

    • Lestersays:

      John yes straights are in gauge.

  • Herveysays:

    Lester,
    I suspect the contacts at the back of the wheels is where the problem is. While gong around the curve the wheels are “squeezed” and make firmer contact with wipers. On the straight the “squeeze” is not there and contact is sporadic at best.
    Check the backs of the wheels and the wipes for accumulated dirt and dust.Carefully clean both with Isoproponal Alcohol being very careful to not bend the wipers.

    • Lestersays:

      thanks Hervey i’ll investigate that. it makes sense

  • phil johnsonsays:

    If this is a Spectrum diesel you may need to remove the shell and trucks to clean the frame and the bronze-phosphor spring on the truck. Oh, yeah, don’t lose the tiny screw holding the truck.

  • Frank MILESsays:

    Phil, Hervey and John all have good points. The only other thing I’d check is make sure the wheels are firmly being held on their axles. I have a similar issue and found a set of wheels were loose on the axle. Hope you find the issue. Good luck..

  • John Haugheysays:

    The longer a conductor is, the more resistance it has. Normally not a problem, but this syndrome can be rectified by adding extra supply booster points in addition to the initial supply point. Also solder joint fishplates as sometimes dirt can accumulate at connections.

  • Chris Bouckleysays:

    Hi Lester, It’s always possible that the engine simply has dirty wheels; the contact would be made with the tracks due to the flanges on the curves, but once it hits the straights, the engine runs on the central portion of the rim which may be dirty. Just a thought. Good luck! Chris.

  • Lestersays:

    thanks all, great advice. thanks for caring

Leave a Reply to Frank MILESCancel reply

Your email address will not be published. Required fields are marked *

Add a photo or image related to your comment (JPEG only)

SUBMIT YOUR QUESTION

Use Tiny Railroad Micro Controllers

Download Your Free Catalog

N Scale Track Plans

Watch Video

Model Train Help Ebook

Model Train DCC HELP

NEW TO MODEL TRAINS?

FREE Tour Inside Club

Take a FREE tour inside the club.

Scenery Techniques Explained

Scenery & Layout Ideas

Model Railroading Blog Archive

Reader Poll

Sorry, there are no polls available at the moment.