Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!
Upgrading Existing Couplers with Remote Control
Jacob posted:
“I saw the attached idea online and wondered if anyone had any experience attaching tiny threads to operate the knuckle coupler?”
Add your comments below.
SUBMIT YOUR QUESTION
I tried this set up on a HO engine. It was a struggle to get everything connected. I tried super glue but it didn’t hold, I ended up using fast set epoxy and that held up better but use it sparingly. The problem I had was the staying tight.
Thread works well for me, I drill a small hole just in front of the spring holder and pass the thread into the hole with a touch of glue.
I use a different motor, it’s a little longer, more powerful and doesn’t burn out if left stalled for too long. They are 3 volt drone motors.
Hope this helps.
Phill.
Found photo
And another when uncoupling
What a great idea = where was this published, I’d like to know more
went looking but lost the webpage link. stupid me. i should have properly saved it. hopefully someone can help us both.