Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!

If You Want Truly Photo-Realistic Plans – You Won’t Find Better!

Switch Wiring Question

Ren T models in N scale and asks:

“Can I wire a red & green LED signal status light to DC Bachmann turnout control switch? I want a green light for mainline direction and and a red light when the switch is not in position to direct trains off the mainline?”

Send in your question for publication. There is a link below.

View the comments, or add a comment to Ren’switch wiring question. There is a link for that below too.

6 Responses to Switch Wiring Question

  • phil johnsonsays:

    some switch machines have extra contacts for signals and to polarize the frog. If your Bachmann has these you are in luck. Although I can’t recall ever seeing them. You might consider dropping Bachmann a email.

  • Jeff Cohensays:

    If you want to go old school, check out the Atlas Snap Relay. The Bachmann switch controller is momentary so as not to burn out the coils in the turnout. If you connect the three wires from the control to the Snap Relay as well as the turnout, the switch control will actuate both at the same time. The Snap relay has additional screw terminals that you can connect to your status light as long as you make sure there’s a resistor in the connection so you don’t burn out the LEDs. Note, Bachmann uses proprietary cable connectors, so you’ll need to be doing some cutting and soldering (or using terminal blocks with a screwdriver).

  • Giosays:

    The relay coil uses 12V to activate, but when the momentary voltage cuts out, the reverse voltage spike could be in the thousands. So be very careful if there is no reverse voltage protection diode installed.

  • Adam Youngsays:

    I used LED lights with a latching relay to make one that works off the momentary switch.

  • Wallysays:

    Use a ‘ Snap Relay” in parallel with the switch relay. I use this these snap relays in my layout.

  • W Rusty Lanesays:

    I also use Atlas snap relays but I don’t use them with lights or LED’s. I guess I could use lights or LED’s but I use the snap relays to change the voltage on the frogs on the diversionary route. I have these wired to two sets of switches or turnouts. Works well after you figure out how to wire them.

Leave a Reply to Jeff CohenCancel reply

Your email address will not be published. Required fields are marked *

Add a photo or image related to your comment (JPEG only)

Download Your Free Catalog

Use Tiny Railroad Micro Controllers

Model Railroad Building House Plans

rail yard buildings

Model Train DCC HELP

N Scale Track Plans

Watch Video

Model Train Help Ebook

Watch These Club Videos

Club members access helpful new resources each month: diagrams, video tutorials, articles, track plans and more. Watch the tour videos here.

Scenery Techniques Explained

NEW TO MODEL TRAINS?

SUBMIT YOUR QUESTION

Submit Your Model Railroading Questions!

Before you submit your model railroading question please add some feedback, answers or comments to other postings on this model train blog. What goes around comes around... so if you can help others in the hobby, someone else may help you.

Important - Please add plenty of supporting details to any question you submit (eg. scale, solutions you have already tried etc.) , as the clearest and best questions usually get the best answers. Also, please check your spelling and punctuation as all questions need to be approved by the blog moderator prior to publication. Approved questions are normally published within a week (if not sooner).

Submit your model train questions here.

Scenery & Layout Ideas

Submit Your Article

Would you like to write an article and have it published?

Preference will be given to articles that help others progress in the hobby, maybe suggesting an idea for their layout, a quick tip or two... or perhaps a little bit of good advice based on your model railroading experiences.

We are all in this hobby together, so the more we can do to share ideas and help each other, the better.

Submit Your Article Here

Model Railroading Blog Archive

Reader Poll

Sorry, there are no polls available at the moment.