Everything on model trains, model railroads, model railways, locomotives, model train layouts, scenery, wiring, DCC and more. Enjoy the world's best hobby... model railroading!
4 Responses to Decoder Installation
Leave a Reply
SUBMIT YOUR QUESTION
Download Your Free Catalog
Use Tiny Railroad Micro Controllers
Model Train Help Ebook
Check with your local hobby shop, they might know someone
They are never as easy as you think when you try to install a decoder. On the other hand they are installed by humans so it is a skill you can learn if you want to. There are numerous videos showing good detail in decoder installation. Anything beyond plug and play will run over an hour if they are showing all the steps. If you don’t feel comfortable after watching the videos go to your local hobby shop. They may do the installations and if they don’t they can recommend who to get in contact with.
If you don’t have a local hobby shop then do a search for “DCC Decoder installers” on the internet.
Yes, there are many people who can install decoders and the ads in model railway magazines or local hobby shops can advise as previously suggested.
However, it’s not difficult to do it yourself as long as you are methodical. Modern locomtives have a decoder socket installed so it’s just a case of accessing the socket (the locomotive instructions will tell you how to do this), taking out the blanking plug and fitting a decoder with the right pin configuration (again, the locomotive instructions or an internet search will tell you what this).
If it’s an old locomotive without a socket, then you need to be more careful. An 8 pin wired decoder is as good a place to start as any but make absolutely certain that the decoder you buy can handle the current your locomotive draws. I have converted several Triang/Hornby locomotives from the 1970s and I had to get decoders that could handle over 1 amp. Sadly I did fry a couple of decoders along the way but you learn these things the hard way!
Normally, it’s just a case of cutting the wires from the pickups to the motor and then soldering the decoder wires to the four bare ends you’ve created:
– Red & black to the pickups on the wheels
– Orange & grey to the motor
The only thing to watch for is some locomotives use the chassis to connect the wheels on one side to the motor so there’s no wire to cut. In these cases, you have to find a way to electrically isolate the motor from the chassis so that you can then connect, say, the black decoder wire to the chassis and the grey decoder wire to the motor.
It sounds harder than it is and once you’ve done a couple, it becomes second nature.
Good luck!
Try a drop-in decoder first. They’re relatively easy. There are also several very good videos and books